Forward/Coast/Direct Clutch Cylinder and Reverse Clutch Drum - Assembly
FORWARD/COAST/DIRECT CLUTCH CYLINDER AND REVERSE CLUTCH DRUM - ASSEMBLYAssembly
Caution: The tabs on the No. 2 direct clutch thrust washer must be seated in the direct clutch support and spring.
1. Install the No. 2 direct clutch thrust washer on the forward/coast/direct clutch cylinder with the tabs facing downward.
2. Install the two reverse clutch cylinder seals.
Note: Make sure that the reverse clutch cylinder seals are overlapped correctly.
3. Position the reverse clutch cylinder seals.
1. Correct installation.
2. Incorrect installation.
4. Support the forward/coast/direct clutch cylinder assembly on a block of wood so that the direct clutch faces upward.
5. Install the direct clutch hub and shell on the for ward/coast/direct clutch cylinder.
6. Install the reverse clutch drum assembly.
7. Install the reverse clutch hub.
8. Support the reverse clutch drum on a block of wood while installing the reverse clutch hub retaining ring.
9. Install the forward/coast/direct clutch cylinder hub seal.
10. Leave special tool attached until the forward/coast/direct clutch cylinder is installed into the transaxle housing.