Driver Air Bag Module Removal/Installation
DRIVE AIR BAG MODULERemoval and Installation
WARNING: Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Do not set a live air bag module down with the trim cover face down. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: When installing a driver air bag module (soft pack), make sure there are no foreign objects in the steering wheel cavity or in the driver air bag module (soft pack). Failure to do so may result in personal injury in the event of an air bag deployment.
WARNING: Do not dislodge the fabric from the air bag module (soft pack). In the event that the air bag fabric becomes dislodged, install a new air bag module (soft pack). Failure to do so may result in personal injury in the event of an air bag deployment.
WARNING: Be careful not to pinch the air bag fabric between the steering wheel and the air bag module housing. In the event the fabric becomes pinched, install a new air bag module (soft pack). Failure to do so may result in the air bag not functioning properly.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: The driver air bag (soft pack) and steering wheel can be serviced separately or as an assembly.
NOTE: In the event of an air bag (soft pack) deployment, the air bag (soft pack) and the steering wheel must be serviced as an assembly.
NOTE: The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
1. Depower the system.
2. Remove the steering wheel.
3. Remove and disconnect the steering wheel accessories.
1. Disconnect and slide the connector off the wire shield.
2. Route the wire harness out of the wire shield.
3. If equipped, remove the screws.
4. If equipped, separate the switches from the steering wheel.
5. Lift the driver air bag module out of the steering wheel.
4. To install, reverse the removal procedure.
- Repower the system.