C-Pillar Trim Panel

Removal and Installation

NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.




1. Remove the safety belt D-ring cover.




2. Remove the safety belt D-ring bolt.




3. Remove the pin-type retainers and the litigate scuff plate trim panel.
4. Position the litigate weatherstrip aside.




5. If equipped, remove the cargo net hold-down.




6. Remove the rear quarter trim panel.
1. Insert a tape-wrapped screwdriver between the D-pillar trim panel and rear quarter trim panel.
2. Push the screwdriver in the direction of the arrow and remove the rear quarter trim panel.




7. Remove the C-pillar trim panel.
8. To install, reverse the removal procedure.