LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> RX8 2RTR-1.3L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transmission Control Systems >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Transmission Speed Sensor >> Service and Repair >> [SJ6A-El] Automatic Transmission/Transaxle

[SJ6A-El] Automatic Transmission/Transaxle

TURBINE SENSOR REMOVAL/INSTALLATION [SJ6A-EL]

Caution:
^ Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.
^ Do not damage the turbine sensor.

1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Disconnect the turbine sensor connector.
5. Remove the turbine sensor.





6. Install the turbine sensor.
Tightening torque 3.9-6.9 N-m (40-70 kgf-cm, 35-60 in-lbf)
7. Connect the turbine sensor connector.
8. Connect the negative battery cable.
9. Install the battery cover.
10. Install the engine cover.
scientia non olet · About LEMON Manuals