Rear Door Striker: Service and Repair

REAR DOOR LOCK STRIKER REMOVAL/INSTALLATION

Upper
1. Remove the following parts:
1. A-pillar trim
2. Sunvisor
3. Assist handle
4. Roof side trim
5. Inner scuff plate
6. Rear seat
7. Tire house trim
8. Rear pillar trim
9. Interior light
10. Map light
11. Headliner




2. Remove the bolts A from the curtain air bag module.




3. Remove the bolt, then remove the bracket.




4. Remove the bolts, then remove the rear door lock striker (upper).
5. Install in the reverse order of removal.
6. Adjust the door.

Lower
1. Remove the outer scuff plate.




2. Remove the screws, then remove the rear door lock striker (lower).
3. Install in the reverse order of removal.
4. Adjust the door.