Muffler And Tailpipe Removal / Installation - 3.0L

WARNING: This page is about a different car, the 2006 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
Remove the nuts and bolts.
NOTE:
- The exhaust hanger insulators can be reused if they show no signs of damage.
Remove the exhaust hanger insulators and discard them if they are damaged.

Fig 1: Identifying Exhaust Hanger Insulators
Courtesy of MAZDA MOTORS CORP.
Remove the tailpipe from the exhaust converter frame bracket.

Fig 2: Positioning The Muffler And Tailpipe Assembly
Courtesy of MAZDA MOTORS CORP.
Position the muffler and tailpipe assembly.
CAUTION:
- To prevent damage to the exhaust insulators do not use oil or grease based lubricants.
NOTE:
- A soap and water solution will ease installation of the exhaust hanger insulators.
Install the exhaust hanger insulators.
Install the tailpipe into the exhaust hanger insulator.
Position the muffler to the catalytic converter and install the nuts and bolts.
Tightening torque

40 Nm {4.1 kgf-m, 30 ft-lbf}
Lower the vehicle.