Exhaust Manifold Right Hand Removal / Installation - 4.0L

Fig 1: Removing/Installing Exhaust Manifold Right Hand With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
2. Disconnect the negative battery cable. See BATTERY DISCONNECT .
   Fig 2: Removing/Installing Bolts With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
3. Remove the bolts.
4. Lower the vehicle.
5. Remove the nuts.
   Fig 3: Removing Exhaust Manifold Nuts

   Courtesy of MAZDA MOTORS CORP.
6. Remove the exhaust manifold and the exhaust manifold gasket.
   Fig 4: Removing Exhaust Manifold

   Courtesy of MAZDA MOTORS CORP.
7. Position the exhaust manifold and the exhaust manifold gasket.
8. Tighten the nuts in the sequence shown.
   Fig 5: Tightening Sequence Of Exhaust Manifold Nuts With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
9. To install, reverse the removal procedure.