Exhaust Manifold Left Hand Removal / Installation

Fig 1: Removing/Installing Exhaust Manifold Left Hand With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
2. Disconnect the negative battery cable. See BATTERY DISCONNECT .
3. Remove the bolts.
   Fig 2: Removing/Installing Bolts With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
4. Lower the vehicle.
5. Disconnect the hoses from the differential pressure feedback EGR transducer.
   Fig 3: Disconnecting Hoses From Differential Pressure Feedback EGR Transducer

   Courtesy of MAZDA MOTORS CORP.
6. Disconnect the EGR valve to exhaust manifold tube.
   Fig 4: Removing/Installing EGR Valve To Exhaust Manifold Tube With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
7. Disconnect the EGR valve to exhaust manifold tube from the EGR valve and remove the EGR valve to exhaust manifold tube.
   Fig 5: Removing/Installing EGR Valve To Exhaust Manifold Tube From EGR Valve With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
8. Remove the exhaust manifold nuts.
9. Remove the exhaust manifold and the exhaust manifold gasket.
10. Position the exhaust manifold and the exhaust manifold gasket.
11. Tighten the nuts in order shown.
    Fig 6: Tightening Exhaust Manifold Nuts In Sequence With Torque Specifications

    Courtesy of MAZDA MOTORS CORP.
12. To install, reverse the removal procedure.