LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft >> Propeller Shaft Rear (4WD) Removal / Installation

Propeller Shaft Rear (4WD) Removal / Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  2. Index-mark the propeller shaft yoke to transfer case companion flange.
    Fig 1: Indexing Companion Flange
    G04308974Courtesy of MAZDA MOTORS CORP.
  3. Index-mark the propeller shaft to rear companion flange.
    Fig 2: Indexing Companion Flange
    G04308975Courtesy of MAZDA MOTORS CORP.
  4. Remove the four rear bolts and disconnect the rear propeller shaft.
    Fig 3: Removing/Installing Bolts With Torque Specifications
    G04308976Courtesy of MAZDA MOTORS CORP.
  5. Separate the propeller shaft from the transfer case.
    1. Remove the four bolts.
    2. Carefully remove the propeller shaft.
    NOTE:
    • Install new bolts.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals