LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle >> Wheel Hub Bolt Circle RUNOUT

Wheel Hub Bolt Circle RUNOUT

NOTE:
  • The brake discs/drums must be removed to perform all runout measurements. See BRAKE DISC or BRAKE DRUM .
  1. Position the Dial Indicator with Bracketry perpendicular to the wheel hub or axle flange bolt, as close to the hub or flange face as possible. Zero the indicator to allow the pointer to deflect either way.
  2. Rotate the hub or flange until the next bolt is contacted. Record the measurement and continue until each bolt is checked. The difference between the maximum and minimum contact readings will be the total wheel hub or axle flange bolt pattern runout. The runout must not exceed 0.38 mm (0.015 inch).
    Fig 1: Checking Wheel Hub Bolt Circle Runout
    G04308689Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals