Belt TENSIONER Removal / Installation - 4.0L

1. Remove the drive belt. See DRIVE BELT REMOVAL / INSTALLATION - 4.0L  .
2. Remove the belt tensioner bolt and the belt tensioner.
3. To install, reverse the removal procedure.

Fig 1: Location Of Alignment Tab On Installation (1 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 2: Location Of Alignment Tab On Installation (2 Of 2)

Courtesy of MAZDA MOTORS CORP.

Tightening Torque 

47 Nm {4.8 kgf-m, 35 ft-lbf}