LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Conventional Brake System >> Brake Fluid Reservoir >> Removal

Brake Fluid Reservoir: Removal

WARNING:
  • Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
  • Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION:
  • Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Disconnect the negative battery cable. See BATTERY DISCONNECT .
  2. Disconnect the brake master cylinder fluid level warning switch.
  3. Using a suitable suction device, drain the brake master cylinder reservoir.
  4. Remove the brake master cylinder reservoir by pulling upward.