LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Panels >> Rear Bumper - Beam >> Removal and Installation All bumpers

Removal and Installation All bumpers

NOTE:
  • This procedure may require an assistant.
  1. Remove the 4 rear bumper beam-to-inner bumper bracket nuts.
    • To install, tighten to 115 N-m (11.7 kgf-m, 85 ft-lbf).
  2. Remove the 2 retainer and bolt assemblies from the rear bumper beam-to-inner bumper brackets.

    Painted bumpers only 

  3. Remove the 2 bolts and nuts from the rear bumper beam-to-outer bumper bracket.
    • To install, tighten to 40 N-m (4.1 kgf-m, 30 ft-lbf).

      All bumpers 

  4. Remove the rear bumper beam.
    • Disconnect the electrical connectors.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals