LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Panels >> Front Bumper >> Removal and installation

Removal and installation

  1. Disconnect the fog lamp electrical connectors, if equipped.
    WARNING:
    • To avoid possible injury, support the front bumper before removing the nuts.
    NOTE:
    • The front bumper and the front bumper cover are removed as an assembly.
  2. Remove the 4 nuts (2 each side) and the front bumper.
    • To install, tighten to 70 N-m (7.1 kgf-m, 52 ft-lbf).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals