Exhaust Manifold Right Hand Removal / Installation - 4.0L

WARNING: This page is about a different car, the 2006 Mazda B4000. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Exhaust Manifold Right Hand With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
Disconnect the negative battery cable. See BATTERY DISCONNECT .

Fig 2: Removing/Installing Bolts With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Remove the bolts.
Lower the vehicle.
Remove the nuts.

Fig 3: Removing Exhaust Manifold Nuts
Courtesy of MAZDA MOTORS CORP.
Remove the exhaust manifold and the exhaust manifold gasket.

Fig 4: Removing Exhaust Manifold
Courtesy of MAZDA MOTORS CORP.
Position the exhaust manifold and the exhaust manifold gasket.
Tighten the nuts in the sequence shown.

Fig 5: Tightening Sequence Of Exhaust Manifold Nuts With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.