Throttle Body Removal / Installation - 2.3L

1. Remove the accelerator control splash shield.
   Fig 1: Removing/Installing Accelerator Control Splash Shield With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
2. Disconnect the wiring harness and engine vent tube from the air cleaner outlet tube.
   Fig 2: Disconnecting Wiring Harness And Engine Vent Tube From Air Cleaner Outlet Tube

   Courtesy of MAZDA MOTORS CORP.
3. Loosen the clamps, the bolt and remove the engine air cleaner intake tube and duct.
   Fig 3: Removing/Installing Clamps & Bolt With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
4. Remove the accelerator cable and the cruise control cable (if equipped).
   Fig 4: Removing Accelerator Cable And Cruise Control Cable

   Courtesy of MAZDA MOTORS CORP.
5. Disconnect the throttle position (TP) sensor electrical connector.
   Fig 5: Disconnecting Throttle Position (TP) Sensor Electrical Connector

   Courtesy of MAZDA MOTORS CORP.
6. Remove the bolts and the throttle body.
   Fig 6: Removing Throttle Body

   Courtesy of MAZDA MOTORS CORP.
7. To install, reverse the removal procedure.
   • Tighten the throttle body bolts in the sequence shown to 10 N.m {1 kgf.m, 7 ft.lbf}.

Fig 7: Tightening Throttle Body Bolts

Courtesy of MAZDA MOTORS CORP.