Safety Belt Minder Deactivating/Activating: Deactivating/Activating
- Turn the ignition switch to the RUN position. (Do not start the engine.)
- Wait until the safety belt warning indicator turns off. (approximately 1 to 2 minutes).NOTE:
- Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.
- Buckle and unbuckle the safety belt 3 times, ending with the safety belt unbuckled.
- Turn the headlamps on then off.
- Buckle and unbuckle the safety belt 3 times ending with the safety belt unbuckled. After this step the safety belt warning indicator will be illuminated for 3 seconds.
- Within 7 seconds of the safety belt warning indicator turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable the belt minder if enabled.
- The following sequence of events confirm the belt minder is enabled:
- flashing of the safety belt warning belt indicator 4 times per second for 3 seconds
- 3 seconds with the safety belt indicator off
- flashing the safety belt indicator 4 times per second for 3 seconds again
- The safety belt indicator flashing 4 times per second for 3 seconds provides confirmation that the belt minder is disabled.
- After confirmation, the deactivation/activation procedure is complete.