Possible Causes

HORN ALWAYS ON PINPOINT TEST REFERENCE

PINPOINT TEST 2		HORN IS ALWAYS ON
STEP	INSPECTION		ACTION
1	CHECK CIRCUIT (Y/LG) FOR A SHORT TO VOLTAGE Key OFF. Disconnect: SJB J-2280a. Does the horn continue to sound?	Yes	Repair circuit (Y/LG) for a short to voltage. Test the system for normal operation.
1		No	Go to next step.
2	CHECK THE SJB FOR INTERNAL FAULTS Key OFF. Connect: SJB J-2280a. Disconnect: J-2280d. Does the horn continue to sound?	Yes	Install a new SJB. See SMART JUNCTION BOX (SJB) . Test the system for normal operation.
2		No	Go to next step.
3	CHECK CIRCUIT (DL) FOR A SHORT TO GROUND Connect: SJB J-2280d. Disconnect: Clockspring 0922-202. Does the horn continue to sound?	Yes	Repair circuit (DL) for a short to ground. Test the system for normal operation.
3		No	Go to next step.
4	CHECK THE CLOCKSPRING FOR A SHORT TO GROUND Remove the driver air bag. See DRIVER AIR BAG MODULE . Connect: Clockspring 0922-202 Disconnect: upper clockspring connector. Measure the resistance between the clockspring 0922-202 pin 5, component side and the upper clockspring pin 5, component side. Is the resistance greater than 10,000 ohms?	Yes	Install a new steering wheel. See STEERING WHEEL . Test the system for normal operation.
4		No	Install a new clockspring. See CLOCKSPRING . Test the system for normal operation.