Possible Causes

fuse(s)
circuit (B) open
circuit (P/B) open
circuit (B/W) open
circuit (R/Y) open
circuit (B/LG) open
instrument cluster

NO COMMUNICATION WITH INSTRUMENT CLUSTER PINPOINT TEST REFERENCE

PINPOINT TEST 1		NO COMMUNICATION WITH THE INSTRUMENT CLUSTER
STEP	INSPECTION		ACTION
1	CHECK THE INSTRUMENT CLUSTER POWER SUPPLY Key OFF. Disconnect: Instrument Cluster 0922-101. Key ON. Using Chart 1 at the end of test, measure the voltage between the instrument cluster, harness side and ground. Are the voltages greater than 10 volts?	Yes	Go to step 2.
1		No	Verify the SJB fuses 9 (5A), 10 (10A), and 33 (5A) are OK. If OK, repair the circuit(s) in question. Test the system for normal operation.
2	CHECK THE INSTRUMENT CLUSTER GROUND CIRCUITS B/W AND B Key OFF. Disconnect: Instrument Cluster 0922-102. Key ON. Using Chart 2 at the end of test, measure the resistance between the instrument cluster, harness side and ground. Are the resistances less than 5 ohms?	Yes	See COMMUNICATIONS NETWORK .
2		No	Repair the circuit(s) in question. Test the system for normal operation.

Chart 1

CONNECTOR PINS AND CIRCUIT REFERENCE

Connector/Pin	Circuit
0922-101-8	R/Y
0922-101-10	B/LG
0922-101-12	P/B

Chart 2

CONNECTOR PINS AND CIRCUIT REFERENCE

Connector/Pin	Circuit
0922-102-1	B
0922-101-3	B/W