Diagnostic Monitoring Test Results
WARNING: This page is about a different variant/trim than selected.
- The purpose of this test mode is to confirm the result of the OBD-II monitor diagnostic test results. The result values stored when a particular monitor is completed are displayed. If the monitor is not completed, the initial value is displayed.DIAGNOSTIC MONITORING TEST RESULTS
TEST ID Description Related system 10:01:80 HO2S (Front) lean-to-rich response time (calculated) HO2S 10: 02: 03 Low HO2S (Rear) voltage for switch time calculation (constant) 10:02:04 High HO2S (Rear) voltage for switch time calculation (constant) 10:02:05 HO2S (Rear) rich-to-lean response time (calculated) 10:21:80 Front and HO2S (Rear) switching time ratio Catalyst 10:31:83 EGR pressure variation EGR 10:3A:80 EVAP system leak detection pump gross leak check EVAP 10:3B:80 EVAP system leak detection pump small leak check 10:3C:80(1) EVAP system leak detection pump very small leak check 10:3D:80 Purge flow monitor 10:A2:0B EWMA misfire counts for last 10 driving cycles Misfire 10:A2:0C Misfire counts for last/current driving cycles 10:A3:0B EWMA misfire counts for last 10 driving cycles 10:A3:0C Misfire counts for last/current driving cycles 10:A4:0B EWMA misfire counts for last 10 driving cycles 10:A4:0C Misfire counts for last/current driving cycles 10:A5:0B EWMA misfire counts for last 10 driving cycles 10:A5:0C Misfire counts for last/current driving cycles 10:E1:80 Heat radiation ratio Engine cooling system 10:E1:81 Misfire counts for last/current driving cycles (1) California emission regulation applicable model