Variable Air Duct (VAD) Control Solenoid Valve Inspection: Notes

WARNING: This page is about a different variant/trim than selected.

Remove the VAD control solenoid valve. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
Inspect airflow between the ports under the following conditions.
- If not as specified, replace the VAD control solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".
  
  Fig 1: Checking VAD Control Solenoid Valve
  
  Fig 2: Identifying VAD Control Solenoid Valve Ports & Connector Terminals