LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle [Service, Removal & Installation A65M-R)) >> Vehicle Speed Sensor Removal/Installation (Without Abs)

Vehicle Speed Sensor Removal/Installation (Without Abs)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the battery and battery tray.
  3. Remove the under cover.
  4. Disconnect the vehicle speed sensor connector.
  5. Remove the vehicle speed sensor.
  6. Apply transaxle oil to a new O-ring and install it on a vehicle speed sensor.
  7. Install the vehicle speed sensor.

    Tightening torque 

    7.8-11.0 N.m 

    {80-112 kgf.cm, 57.6-81.1 in.lbf} 

  8. Connect the vehicle speed sensor connector.
  9. Install the under cover.
  10. Install the battery and battery tray.
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals