Vehicle Speed Sensor Removal/Installation (Without Abs)
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable.
- Remove the battery and battery tray.
- Remove the under cover.
- Disconnect the vehicle speed sensor connector.
- Remove the vehicle speed sensor.
- Apply transaxle oil to a new O-ring and install it on a vehicle speed sensor.
- Install the vehicle speed sensor.
Tightening torque
7.8-11.3 N.m
{80-115 kgf.cm, 69.5-99.8 in.lbf}
- Connect the vehicle speed sensor connector.
- Install the under cover.
- Install the battery and battery tray.
- Connect the negative battery cable.