LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transaxle [Service, Removal & Installation G35M-R]) >> Oil Seal (Differential) Replacement

Oil Seal (Differential) Replacement

WARNING: This page is about a different variant/trim than selected.
  1. On level ground, jack up the vehicle and support it evenly on safety stands.
  2. Drain the oil from the transaxle.
  3. Remove the front wheels and splash shields.
  4. Separate the drive shaft and joint shaft from the transaxle. (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION [L3, L3 WITH TC]. ) (See JOINT SHAFT REMOVAL/INSTALLATION [L3]. )
  5. Remove the oil seals using a screwdriver.
    Fig 1: Removing Oil Seal
    G04326136Courtesy of MAZDA MOTORS CORP.
  6. Using the SST  and a hammer, tap each new oil seal in evenly until the SST  contacts the transaxle case.
  7. Coat the lip of each oil seal with transaxle oil.
  8. Insert the drive shaft and joint shaft to the transaxle. (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION [L3, L3 WITH TC]. ) (See JOINT SHAFT REMOVAL/INSTALLATION [L3]. )
  9. Install the wheels and splash shields.
  10. Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT ).
    Fig 2: Installing Oil Seal
    G04326137Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals