Bracket Installation Note (Except for California Emission Regulation Applicable ATX Model)
WARNING: This page is about a different variant/trim than selected.
- Temporarily tighten the exhaust manifold side bolts.
- Verify that the gap between the exhaust manifold and the bracket is 2.0-4.0 mm {0.08-0.16 in}.
- Fully tighten the cylinder block side bolt.
Tightening torque
38-51 N.m {3.9-5.2 kgf.m, 29-37 ft.lbf}
- Fully tighten the exhaust manifold side bolts.
Tightening torque
40-55 N.m {4.1-5.6 kgf.m, 29.5-40.5 ft.lbf}