LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical [Service Information L3)) >> Engine Tune-Up >> Idle Speed Inspection

Idle Speed Inspection

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Idle speed is not adjustable.
  • Idle speed verification requires WDS or equivalent.
  1. Verify that the idle speed (WDS: RPM PID) is within the specification using WDS or equivalent.

    Standard 

    ENGINE SPEED CONDITION

    Condition Engine speed (RPM)(1)
    N, D position (ATX), Neutral position (MTX)
    ATX MTX
    N range D range
    No load 650-750 600-700 650-750
    Electrical loads(2) ON 650-750 650-750 650-750
    P/S ON 650-750 650-750 650-750
    A/C ON and refrigerant pressure switch (middle) OFF 700-800 700-800 700-800
    A/C ON and refrigerant pressure switch (middle) ON 700-800 700-800 700-800
    (1) Excludes temporary idle speed drop just after the electrical loads are turned on.
    (2) Blower motor is operating at high speed. Headlight switch is turned on. Rear window defroster switch is turned on. Cooling fans are operating.
scientia non olet · About LEMON Manuals