LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical [Service Information L3)) >> Engine Tune-Up >> Engine Tune-up Preparation

Engine Tune-up Preparation

WARNING: This page is about a different variant/trim than selected.
  1. Turn off the electrical loads.
  2. Warm up the engine as follows.
    1. Start the engine.
    2. Maintain the engine speed 2,500-3,000 RPM  until the cooling fans start to operate.
    3. Release the accelerator pedal.
    4. Wait until the cooling fans stop.
  3. Connect the SST  (WDS or equivalent) to the DLC-2.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals