LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Automatic Transaxle - Overhaul (FS5A-El)) >> SECONDARY CONTROL VALVE BODY DISASSEMBLY/ASSEMBLY Secondary Control Valve Body Disassembly >> Secondary Main Control Valve Body Disassembly/Assembly

Secondary Main Control Valve Body Disassembly/Assembly

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Denting or scratching these precisely machined components will reduce the ability of the transaxle to shift properly. When handling these components or the valve body that contains them be careful not to drop or hit them.
NOTE:
  • If a valve does not slide out under its own weight, place the valve body open-side down and tap on the valve body lightly with a plastic hammer.
  1. Disassemble in the order indicated in the table.
    WARNING:
    • Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.
  2. Clean all parts and holes using compressed air and apply ATF to them immediately before assembly.
  3. Assemble in the reverse order of disassembly.
    Fig 1: Identifying Secondary Main Control Valve Body Components
    G05118812Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals