Disassembly procedure

WARNING: This page is about a different variant/trim than selected.

Remove the bracket.

Fig 1: View Of Bracket
Courtesy of MAZDA MOTORS CORP.
Remove the pressure control solenoid B and shift solenoid F.

Fig 2: View Of Pressure Control Solenoid B And Shift Solenoid F
Courtesy of MAZDA MOTORS CORP.
Remove the 4/5 accumulator plate.

Fig 3: View Of 4/5 Accumulator Plate
Courtesy of MAZDA MOTORS CORP.
Remove the 4/5 accumulator large spring, 4/5 accumulator small spring and 4/5 accumulator.

Fig 4: View Of 4/5 Accumulator Large Spring
Courtesy of MAZDA MOTORS CORP.
Loosen the bolts evenly in the pattern shown.

Fig 5: Identifying Bolts
Courtesy of MAZDA MOTORS CORP.
Remove the secondary lower control valve body.

Fig 6: View Of Secondary Lower Control Valve Body
Courtesy of MAZDA MOTORS CORP.
Remove the gasket G, separator plate and gasket H.

Fig 7: View Of Gasket G, Separator Plate And Gasket H
Courtesy of MAZDA MOTORS CORP.
Remove the tubular pins.

Fig 8: View Of Tubular Pins
Courtesy of MAZDA MOTORS CORP.