Disassembly procedure

WARNING: This page is about a different variant/trim than selected.

Remove the oil strainer.
Remove the O-ring from the oil strainer.
Remove the packing.
Remove the bracket.

Fig 1: View Of Bracket
Courtesy of MAZDA MOTORS CORP.
Remove the shift solenoid A, B, C.

Fig 2: View Of Shift Solenoid
Courtesy of MAZDA MOTORS CORP.
Remove the pressure control solenoid A, shift solenoid D, E.

Fig 3: View Of Pressure Control Solenoid A, Shift Solenoid D, E
Courtesy of MAZDA MOTORS CORP.
Loosen the bolts evenly.

Fig 4: Identifying Bolts
Courtesy of MAZDA MOTORS CORP.
Remove the upper control valve body.

Fig 5: View Of Upper Control Valve Body And Main Control valve Body
Courtesy of MAZDA MOTORS CORP.
Remove the seal plate.

Fig 6: View Of Seal Plate
Courtesy of MAZDA MOTORS CORP.
Remove the main control valve body.

Fig 7: View Of Main Control Valve Body
Courtesy of MAZDA MOTORS CORP.
Remove the tubular pins, pressure modifier accumulator spring and pressure modifier accumulator from the main control valve body.

Fig 8: View Of Tubular Pins, Pressure Modifier Accumulator Spring And Pressure Modifier Accumulator
Courtesy of MAZDA MOTORS CORP.
Remove the gasket D, separator plate and gasket C.

Fig 9: View Of Gasket D, Separator Plate And Gasket C
Courtesy of MAZDA MOTORS CORP.
Remove the tubular pins.

Fig 10: View Of Tubular Pins
Courtesy of MAZDA MOTORS CORP.