LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Automatic Transaxle - Overhaul (FS5A-El)) >> Front Internal Gear One-Way Clutch No.1 Component Disassembly/Assembly >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the snap ring.
  2. Install the one-way clutch No.1 to the front internal gear in the direction of the arrow (on the one-way clutch) as shown in the figure.
  3. Install the side race.
  4. Install the one-way clutch retainer.
Fig 1: View Of One-Way Clutch Retainer
G05118717Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals