Brake operation
WARNING: This page is about a different variant/trim than selected.
- Set the direct clutch drum onto the transaxle case.CAUTION:
- Applying compressed air to the assembled clutch pack for longer than 3 s at a time will damage the seal.
Do not apply compressed air for more than the aforementioned time when testing the system.
- Applying compressed air to the assembled clutch pack for longer than 3 s at a time will damage the seal.
- Inspect the brake operation by applying compressed air as shown.
Air pressure
392 kPa {4.0 kgf/cm 2 , 57 psi} max.
- If not as specified, replace parts as necessary. (See REDUCTION BRAKE DISASSEMBLY/ASSEMBLY .)