Low and Reverse Brake Preinspection Brake operation

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Applying compressed air to the assembled clutch pack for longer than 3 s at a time will damage the seal.
Do not apply compressed air for more than the aforementioned time when testing the system.

Inspect the brake operation by applying compressed air as shown.
Air pressure

392 kPa {4.0 kgf/cm ² , 57 psi} max.
If not as specified, replace parts as necessary. (See LOW AND REVERSE BRAKE AND ONE-WAY CLUTCH INNER RACE DISASSEMBLY/ASSEMBLY .)

Fig 1: Applying Compressed Air To Low And Reverse Brake Fluid Passage

Courtesy of MAZDA MOTORS CORP.