Clutch operation

WARNING: This page is about a different variant/trim than selected.

Set the direct clutch drum onto the transaxle case.
CAUTION:
- Applying compressed air to the assembled clutch pack for longer than 3 s at a time will damage the seal.
  Do not apply compressed air for more than the aforementioned time when testing the system.
Inspect the clutch operation by applying compressed air as shown.
Air pressure

392-441 kPa {4.0-4.5 kgf/cm ² , 57-63 psi}
If not as specified, replace parts as necessary. (See DIRECT CLUTCH DISASSEMBLY/ASSEMBLY .)

Fig 1: Applying Compressed Air To Direct Clutch Fluid Passage
Courtesy of MAZDA MOTORS CORP.