LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Automatic Transaxle - Overhaul (FS5A-El)) >> Forward Clutch Disassembly/Assembly >> Snap Ring Disassembly Note

Snap Ring Disassembly Note

WARNING: This page is about a different variant/trim than selected.
  1. Install the SST  to the forward clutch.
    CAUTION:
    • Depress the seal plate only enough to remove the snap ring. Overpressing will damage the seal plate assembly edges.
  2. Compress the seal plate.
  3. Remove the snap ring.
  4. Remove the SST  , then remove the seal plate and spring and retainer component.
    Fig 1: Removing Seal Plate And Spring And Retainer Component
    G05118678Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals