LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (All Wheel Drive (AWD)) >> AWD Solenoid Inspection

AWD Solenoid Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Disconnect the AWD solenoid connector.
  3. Measure resistance between AWD solenoid connector terminals A and B.
    • If the resistance is not within the specification, replace the coupling unit.

    AWD solenoid resistance 

    1.5-2.0 ohms 

    (Rear differential oil temperature at 20°C {68°F}) 

  4. Connect the AWD solenoid connector.
  5. Connect the negative battery cable.
    Fig 1: Measuring Resistance Between AWD Solenoid Connector Terminals A And B
    G04325759Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals