No. 4 Engine Mount Bracket Installation Note

WARNING: This page is about a different variant/trim than selected.

Set the transaxle on a garage jack and lift it.
Verify that the engine mount rubber is installed as shown.
By aligning the holes with the stud bolts, install the No.4 engine mount bracket to the transaxle.
Align the hole of the No.4 engine mount bracket with the No.4 engine mount rubber on vehicle, and temporarily tighten nut D.
Lightly tighten nuts B, C and bolt A.
Tighten nuts B, C in order of B-->C, then bolt A.

Fig 1: Setting Transaxle On A Floor Jack
Courtesy of MAZDA MOTORS CORP.
Tighten nut D.
Tightening torque

A, B, C: 66.6-93.1 N.m

{6.8-9.4 kgf.m, 49.2-68.6 ft.lbf}

D: 85.3-116.6 N.m

{8.7-11.8 kgf.m, 62.9-85.9 ft.lbf}
Remove the garage jack.
Remove the SST (49 C017 5A0).

Fig 2: No. 4 Engine Mount Bracket
Courtesy of MAZDA MOTORS CORP.