Ignition Coil With Built-in Igniter Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ignition coil connector.
- Measure the resistance between each terminal on the ignition coil connector using an analog circuit tester.
- If the measurement corresponds to the table, replace the ignition coil.
TESTER CONNECTION POSITION
| Item | Tester Connection Position | Condition | |
|---|---|---|---|
| Positive | Negative | ||
| Terminal | C | A | 0 ohm is not normal (infinity ohm is normal) |
| A | C | ||
| C | B | ||
| B | C | ||
| A | B | Infinity or 0 ohm is not normal (several kilohm is normal) | |
| B | A | ||