LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Starting System (L3 With TC)) >> Starter Inspection >> Starter Inner Parts Inspection >> Magnetic switch

Magnetic switch

WARNING: This page is about a different variant/trim than selected.
  1. Inspect for continuity between terminals S and M using a tester.
    • If there is no continuity, replace the magnetic switch.
      Fig 1: Verifying Continuity Between Terminals S And M
      G04325098Courtesy of MAZDA MOTORS CORP.
  2. Inspect for continuity between terminal S and the body using a tester.
    • If there is no continuity, replace the magnetic switch.
      Fig 2: Verifying Continuity Between Terminal S And Body
      G04325099Courtesy of MAZDA MOTORS CORP.
  3. Verify that there is no continuity between terminals M and B using a tester.
    • If there is continuity, replace the magnetic switch.
      Fig 3: Verifying Continuity Between Terminals M And B
      G04325100Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals