LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Oil Cooler Removal/Installation >> Oil Pipe, Hose Clamp, Oil Hose Installation Note

Oil Pipe, Hose Clamp, Oil Hose Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Apply compressed air to the cooler-side opening, and blow any remaining grime and foreign material from the cooler pipes. Compressed air should be applied for no less than one minute  .
    Fig 1: Clearing Oil Cooler Pipes Using Compressed Air
    G04326323Courtesy of MAZDA MOTORS CORP.
  2. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.
    NOTE:
    • If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose camp. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.
  3. Install the new hose clamp onto the hose.
  4. Verify that the hose clamp does not interfere with any other components.
    Fig 2: Sliding Oil Hose Onto Oil Pipe
    G04326324Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals