Drive Plate Installation Note
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Clean the crankshaft threads before tightening the bolts. The threads may be damaged if the bolts are tightened with any old sealant remaining.
- Clean the crankshaft thread holes.
- Install the drive plate.
- Install the adapter.
- Set the SST or equivalent against the drive plate.
- Tighten the new drive plate mounting bolts in two or three steps in the order shown.
Tightening torque
108-116 N.m
{11.0-11.8 kgf.m, 79.7-85.5 ft.lbf}
- Install the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION ).