Torque Converter Nuts Installation Note

WARNING: This page is about a different variant/trim than selected.

Hold the crankshaft pulley to prevent drive plate from rotating.
CAUTION:
- Loosely and equally tighten the torque converter nuts, then further tighten them to the specified tightening torque.
  
  Fig 1: Holding Crankshaft Pulley
  Courtesy of MAZDA MOTORS CORP.
Tighten the torque converter mounting nuts.
Tightening torque

34.3-60.8 N.m {3.5-6.2 kgf.m, 25-45 ft.lbf}

Fig 2: Tightening Torque Converter Mounting Nuts
Courtesy of MAZDA MOTORS CORP.