No. 1 Engine Mount and No. 4 Engine Mount Bracket Installation Note
WARNING: This page is about a different variant/trim than selected.
- Verify that the engine mount rubbers are installed as shown.
- By aligning the holes with the stud bolts, install the No.4 engine mount bracket to the transaxle.
- By aligning the holes with the stud bolts, install the No.1 engine mount to the transaxle.
- Align the hole of the No.4 engine mount bracket with the No.4 engine mount rubber on vehicle, and temporarily tighten the bolt D.
- Tighten the nut B, C in order of B-->C, then bolt A.
- Tighten the bolt D.
Tightening torque
A, B, C: 66.6-93.1 N.m {6.8-9.4 kgf.m, 50-68 ft.lbf}
D: 85.3-116.6 N.m {8.7-11.8 kgf.m, 63-85 ft.lbf}
- Tighten the bolt E to the No.1 engine mount.
Tightening torque
E: 85.3-116.6 N.m {8.7-11.8 kgf.m, 63-85 ft.lbf}
- Remove the SST (49 C017 5A0).