LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Charging System (L3 With TC)) >> Generator Inspection [L3 With TC] >> Generator Warning Light

Generator Warning Light

WARNING: This page is about a different variant/trim than selected.
  1. Verify that the battery is fully charged.
    • Charge if necessary.
  2. Verify that the drive belt deflection/tension is within the specification. (See DRIVE BELT INSPECTION [L3 WITH TC] ).
  3. Turn the ignition switch on and verify that the generator warning light illuminates.
    • If not as specified, inspect the generator warning light, and wiring harnesses between the battery and the generator warning light.
  4. Verify that the generator warning light goes out after the engine is started.
    • If not as specified, inspect if any of the following DTCs are displayed: P0112, P0113, P2502, P2503, P2504. (See DTC TABLE [L3 WITH TC] ).
scientia non olet · About LEMON Manuals