LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Symptom Troubleshooting [Engine Control System L3)) >> No. 9 Fast Idle/Runs On >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 Connect WDS or equivalent to DLC-2.
Access ECT PID.
Start and warm up engine to normal operating temperature.
Is ECT PID reading between 82-112°C {180-234°F}  ?		 Yes Go to the next step.
No ECT PID is higher than 112°C {234°F}: 
Go to symptom troubleshooting "NO. 17 COOLING SYSTEM CONCERNS-OVERHEATING ".
ECT PID is less than 82°C {180°F}: 
Go to symptom troubleshooting "NO. 18 COOLING SYSTEM CONCERNS-RUNS COLD ".
2 Connect WDS or equivalent to DLC-2.
Turn ignition switch to ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?		 Yes DTC is displayed: 
Go to appropriate DTC test.
No No DTC is displayed: 
Go to the next step.
3 Connect the WDS or equivalent to DLC-2.
Inspect the value at the following PCM and TCM (ATX) PIDs.
PCM PIDs: 
  • AC_REQ
  • COLP
  • CPP (MTX)
  • CPP/PNP (MTX)
  • PSP

TCM PID: 
  • TR

Are the PID values normal?		 Yes Go to the next step.
No If the AC_REQ PID is not specified: 
Inspect A/C switch, refrigerant pressure switch (low/high) and fan switch.
If the COLP PID is not specified: 
Inspect refrigerant pressure switch (middle).
If the CPP PID is not specified: 
Inspect clutch switch.
If the CPP/PNP PID is not specified: 
Inspect neutral switch.
If the PSP PID is not specified: 
Inspect power steering pressure switch.
If the TR PID is not specified: 
Inspect TR switch.
4 Is there air leakage felt or heard at intake-air system components while racing engine to higher speed? Yes Repair or replace parts if necessary.
No Inspect the following:
  • Electronic throttle control system operation
  • Accelerator position sensor adjustment
5 Verify test results.
  • If okay, return to diagnostic index to service any additional symptoms.
  • If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
    • If vehicle is repaired, troubleshooting completed.
    • If vehicle is not repaired or additional diagnostic information is not available, reprogram PCM if later calibration is available. Retest.
scientia non olet · About LEMON Manuals