Warm-Up Three-Way Catalytic Converter (WU-TWC) Inspection
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Perform the following procedures, DTC P0421 is indicated only.
- Connect the WDS or equivalent to the DLC-2.
- Start the engine and warm it up to normal operating temperature.
- Turn off the engine.
- Verify that the engine compression is within the specification. (See
COMPRESSION INSPECTION
).
- If the compression pressure is not within the specification, repair or replace the malfunction part.
- Drive the vehicle for 10 min at 65-96 km/h {40-60 mph} to allow the WU-TWC to reach operating temperature.
- Stop the vehicle and leave it in a safe space.
- Access Test ID 10:21:80 on the "Diagnostic Monitoring Test Result" function.
- Verify that the test result is within the specified indicated on the WDS or equivalent.
- If it is not as specified, replace the WU-TWC. (See EXHAUST SYSTEM REMOVAL/INSTALLATION ).