Airflow Inspection

WARNING: This page is about a different variant/trim than selected.

NOTE:

Perform the following test only when directed.

Disconnect the negative battery cable.
Remove the purge solenoid valve. (See ENGINE COMPARTMENT SIDE ).
Inspect airflow between the ports under the following conditions.
- If not as specified, replace the purge solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".
  
  Fig 1: Checking Purge Solenoid Valve Continuity
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Identifying Purge Solenoid Valve Connector Terminals
  Courtesy of MAZDA MOTORS CORP.