LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Emission System (L3 With TC)) >> Evaporative Emission (EVAP) System Leak Detection Pump Inspection >> Resistance Inspection

Resistance Inspection

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Perform the following procedure only when directed.
  1. Disconnect the negative battery cable.
  2. Inspect resistance of the EVAP system leak detection pump.
    • If not as specified, replace the EVAP system leak detection pump.
    • If as specified, carry out the "Circuit Open/Short Inspection".
      TERMINAL RESISTANCE REFERENCE

      Terminals Resistance (ohm)
      A-B 20-50
      A-C 26.6-32.4
      A-D MAX. 118
      Fig 1: Checking EVAP System Leak Detection Pump
      G04325000Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals