Variable Swirl Solenoid Valve Inspection: Notes

WARNING: This page is about a different variant/trim than selected.

Remove the variable swirl solenoid valve. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
Inspect the airflow between the ports under the following conditions.
- If not as specified, replace the variable swirl control solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".
  
  Fig 1: Testing Variable Swirl Solenoid Valve Connector Terminal Circuit
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Identifying Variable Swirl Solenoid Valve Ports
  Courtesy of MAZDA MOTORS CORP.