Continuity Inspection

WARNING: This page is about a different variant/trim than selected.

NOTE:

Perform the following test only when directed.

Disconnect the negative battery cable.
Remove the service hole cover. See FUEL PUMP UNIT REMOVAL/INSTALLATION .
Disconnect the fuel pump unit connector.
Inspect for continuity between fuel pump unit connector terminals B and D.
- If there is no continuity, replace the fuel pump body.
- If as specified, carry out the "Circuit Open/Short Inspection".
  
  Fig 1: Identifying Fuel Pump Unit Connector Terminals
  Courtesy of MAZDA MOTORS CORP.